Page 1 of 1
Help with pitch / mod wheel graphics
Posted: Tue Mar 20, 2018 7:18 am
by Bluntmaster
I have download the pack of pitch / mod wheels and I cannot find out how to export the graphics inside the schematic.
A little guidance is needed.
Re: Help with pitch / mod wheel graphics
Posted: Tue Mar 20, 2018 9:06 am
by Spogg
I don't know what controls you have so it would help if you could upload them.
However, if you want to save a bitmap or strip (for knobs typically) you can use the module in the attached schematic.
I have a pitchbend wheel which just uses prims to create it (no image file). In this case you would have to do a screen capture.
Cheers
Spogg
Re: Help with pitch / mod wheel graphics
Posted: Mon Mar 26, 2018 7:47 am
by Bluntmaster
Thanks Spogg, unfortunately I havent learned enough Flowstone yet to be able to hook up my wheels to the file you shared. Do you think you might have the time to hook them up for me so I can see how it is done ?
If so here are the wheels, thanks in advance.
Re: Help with pitch / mod wheel graphics
Posted: Tue Mar 27, 2018 9:08 am
by Spogg
Bluntmaster wrote:If so here are the wheels, thanks in advance.
I don't see an attachment!
Cheers
Spogg
Re: Help with pitch / mod wheel graphics
Posted: Tue Mar 27, 2018 9:14 am
by Bluntmaster
Yeah sorry about that, my demo time expired.