Hey djbrynte, welcome.
I can knock off a few of the simple questions, the rest is a complex story, best left to gurus.
djbrynte wrote:What is flowstone?
malc quoted it as "Synthmaker 3"....just with a lot new stuff for his new "robotics" community.
Some agree... others would disagree....
djbrynte wrote:Can i open sm filés in flowstone?
yes..sm to fs all good.......fs to sm = NO.
djbrynte wrote:Is There gona be able for mac or 64 bit?
Quite a few people waiting on 64-bit.....malc updating in stages = waiting game..
djbrynte wrote:Are The support gona be better here?
Support is ok...but seems the general consensus is that "DSPR" are not delivering here
for the price we are paying, so there's people dropping out....not paying... so they can wait
till they see
" when" they need to come on board again.
I think it's clever...it's like an escape clause...it's like malc saying "hey man, I'm real busy,
I might not be on-time with the update, so yeh, bail out..don't pay....when you see an update
appear that you want/need....start paying again"...or something like that..
djbrynte wrote:Is There anything Else i need to know?
Heaps......
..
Gurus
djbrynte wrote:And hope there is gona be same awesome people from sm!
I wish malc would just end it...give all reg sm users a free copy....and bring the whole
community over.
..never happen though..
djbrynte wrote:can i have both sm and fs installed?
yes..
Download Free FS version and have a go
Go through user manual.....
Dont forget to right click and notice another way to access the toolbox....
Or right click some prims....
Take it slow.....lots of examples to go through....will fry your brain...
Can you code???.. enabling you to take advantage of Ruby...?
If you can code you'll probably love it...
if you can't code....it can be an extremely slow process..the learning curve is
massive....but the good news is that Ruby is much easier to learn than dsp code...