DSP Robotics Support

Any recommedation/experience with a pressure sensor that works together with FlowBoard DAQ
and Flowstone and can be sampled at 10 ms. Sensitivity should be at least 10 Pa or lower.
Thanks, Gernot

You could just use the pressure sensor from Phidgets and connect it to the FlowBoard DAQ

You might need to use a potential divider (2 resistors)to get the correct voltage range for the FlowBoard (3.3V)

Heres the link :

http://www.phidgets.com/products.php?category=1&product_id=1115

Edit: Just noticed you wanted a lower pressure ;(

Thank you Cat5

I am not sure at would sample rate I could get data from the Phidget pressure sensor. If they can sample at down to 10 ms it would be great.

Cheers