D flip flop

[BobF]

Bobs Div x2_4_8.fsm

(149.33 KiB) Downloaded 1013 times

Hello gang,

Here is another module I created, the D type Flip Flop with a demo of one use for it. A divide by 2 for square waves (It will take a sine or triangle also , but acts a little different with saws and ramps). It acts very much like a real TTL D Flip Flop for those familiar with TTL logic hardware. It only outputs from 0 to 1 square waves. There are comments inside the FSM, so please read it for more information. *** Some feedback would really be appreciated.

Comments, suggestions, improvements, uses, and etc. are always welcome. If anyone has any ideas on optimizing this I would really like to hear from you. If used for commercial use though, please contact me.

Later then, BobF.....

[Spogg]

Hi

Have look inside this and you'll see a completely different approach!

Cheers

Spogg