If you have a problem or need to report a bug please email : support@dsprobotics.com
There are 3 sections to this support area:
DOWNLOADS: access to product manuals, support files and drivers
HELP & INFORMATION: tutorials and example files for learning or finding pre-made modules for your projects
USER FORUMS: meet with other users and exchange ideas, you can also get help and assistance here
NEW REGISTRATIONS - please contact us if you wish to register on the forum
Users are reminded of the forum rules they sign up to which prohibits any activity that violates any laws including posting material covered by copyright
Yost Engineering Servo Center Test
1 post
• Page 1 of 1
Yost Engineering Servo Center Test
by admin » Thu Nov 17, 2011 8:21 pm
In this example we control a single servo (S0) on the Yost Engineering Servo Center board.
In this case we are using the USB virtual Comport driver supplied with the board. We have set up the Com port to be Com 8.
There are two ways of communicating with the Servo Center via ASCII or Via HEX so we have made two example one for each.
More information visit: http://tech.yostengineering.com/servoFolder
- Servo CenterLR.png (229.24 KiB) Viewed 35207 times
In this case we are using the USB virtual Comport driver supplied with the board. We have set up the Com port to be Com 8.
There are two ways of communicating with the Servo Center via ASCII or Via HEX so we have made two example one for each.
- ServoCenter ASCII clip.png (42.83 KiB) Viewed 35207 times
More information visit: http://tech.yostengineering.com/servoFolder
- Attachments
-
ServoCenter ASCII.fsm- (9.55 KiB) Downloaded 3363 times
-
- ServoCenter HEX.fsm
- (9.43 KiB) Downloaded 3365 times
-
admin - Site Admin
- Posts: 231
- Joined: Tue May 11, 2010 6:30 pm
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest