DSP Robotics Support

Help! I’m baffled by this!

Pitch to Freq issue:

If I use a green value from a knob to set a note number and put an Int prim on it, the pitch should increase in whole semi-tone steps but it ignores the value from the Int prim and operates smoothly with no exact intervals. Unless I attach just the output from a de-zip to the P-F input, then the Int works. This is the same for Martin’s Pitch to Freq converter.

See the note in the attached schematic.

WTF?

Cheers

Spogg

Works OK here: Take your schematic as it is, turn knob, get semitone schanges.

Thanks for checking this out Martin.

I was about to delete the post because I rebooted the PC and now it works. I'd previously closed and re-opened FS and the issue remained, so some corruption from FS seems to have stayed in memory even with the program closed.
It's the only explanation I can think of.

I guess I should have tried a reboot before asking for help

Thanks again.

Spogg